Sis Configuration And Control; Host Control Ports; Rear Panel Rs-232 Port; Front Panel Configuration Usb Port - Extron electronics DMP 64 Plus User Manual

SIS Configuration
and Control
Use Simple Instruction Set (SIS) commands to configure the DMP 64 Plus. This section
provides information about using those commands. Topics include:
•
•
•
•
•
•

Host Control Ports

Rear Panel RS-232 Port

The DMP 64 Plus has a rear panel serial port (see figure 2,
can be connected to a host device such as a computer running Extron DataViewer or
HyperTerminal utilities, available at www.extron.com. The port makes serial control of the
switcher possible. Use the protocol information listed below to make the connection.
The protocol for the Remote serial port is as follows:
•
•
NOTE: The rear panel configuration port requires 38400 baud communication. This

Front Panel Configuration USB Port

The front panel USB Mini-B type port (see figure 8,
to a computer as a host device running either the HyperTerminal or DataViewer utilities for
control of the device. Once a connection is established, SIS programming can begin.

Ethernet (LAN) Port

The rear panel Ethernet ports (see figure 2,
WAN. Communications between the switcher and the controlling device is via Telnet, using
port 23. The Telnet port can be changed, if necessary, via SIS, using Dataviewer, or other
port configuration application. This connection makes SIS control of the unit possible using
a computer connected to the same LAN or WAN.
Host Control Ports
Simple Instruction Set Control
Command and Response Table for SIS Commands
Command and Response Table for DSP SIS Commands
Command and Response Table for VoIP SIS Commands
Object ID (OID) Number Tables
38400 baud
8 data bits
speed is higher than most other Extron products. The DMP 64 Plus control software
automatically sets the connection for the appropriate speed. When using DataViewer
or similar application, make sure the host PC or control system is set for 38400 baud.
• No parity
• No flow control
on page 8) can be connected
B
) can be connected to an Ethernet LAN or
F
DMP 64 Plus• SIS Configuration and Control
on page 4) that
E
• 1 stop bit
34