Starting A Job; Engage Steering; Updating Rs1 - Raven RS1 Calibration And Operation Manual

Hide thumbs Also See for RS1:

Table of Contents

HAPTER

STARTING A JOB

Refer to the ROS (Raven Operating System) Basic Operation Manual (P/N 016-0171-539) for instructions on starting

a job and setting guidance lines.

FIGURE 1. RS1 Status Widget on ROS

NOTE:

If the steering widget does not appear on the screen, refer to the Viper/Viper 4+ Installation and

Operation manual (P/N 016-0171-539) for further information on adding widgets.

NOTE:

The operator liability waiver must be accepted before the RS1 system can be enabled for operation.

The RS1 steering may also be engaged using the following methods:

• Tap the foot switch or rocker switch to engage RS1 features during field operation.

• Press the RS1 on-screen status widget to engage the RS1 during field operation.

Refer to the Field Updates section on page 101 or the field computer manual for instructions on updating the RS1

software.

Raven RS1™ and RS Lite™ Calibration and Operation Manual

RS1 Status

Widget

Table of Contents

Rs lite