Certification And Compliance; Roadway Homologation - Raven RS1 Calibration And Operation Manual

Hide thumbs Also See for RS1:

Table of Contents

CHAPTER

The Accept Roadway Homologation Terms page will be displayed during the initial calibration of the RS1 system in

either of the following conditions:

• Operating with a generic tune-set

• Operating on the European continent

Carefully review the on-screen disclaimer before proceeding.

FIGURE 1. Roadway Homologation

When roadway homologation is accepted (check box enabled), the following parameters will be applied to RS1

operation:

• An operator presence method will be required while operating with the RS1 auto-steering system enabled.

• Auto-steering cannot be enabled above 16.1 km/h [10 mph].

• Auto-steering will disengage above 19.3 km/h [12 mph].

NOTE:

To engage and operate with autosteering higher than the limits above, review the disclaimer on the

page and do not accept the homologation terms.

016-4010-001 Rev. J

C ERTIFICATION AND

C H A P T E R 1 3

COMPLIANCE

111

Table of Contents

Rs lite