Controller Panel - Smartgen HGM8110DC-2 User Manual

Icon
Confirm
Exit
NOTE: In manual mode, press
controller won't judge whether genset has been started according to crank disconnect conditions, but starter separation is
controlled by operator. When operator observes genset has been started, release the buttons, start output will be stopped
and controller will enter Safety On Delay.
CAUTION! Default password is "00318", operator can change the password to prevent others changing advanced
configurations randomly. Please remember the password clearly after change. In case that you forget it, please contact
company personnel and feedback PD information in ABOUT page to service personnel.

5.2 CONTROLLER PANEL

NOTE: Partial indicators illustration:
Alarm Type
No Alarm
Warning
Trip Alarm
Shutdown Alarm
Trip and Stop Alarm
NOTE 1: Status indicator: illuminated from crank disconnect to ETS while off during other periods.
NOTE 2: Gens normal Indicator：It is light on when generator is normal; flashing when generator state is abnormal; off
when there is no generator power.
HGM8110DC-2 Genset Controller
HGM8110DC-2 GENSET CONTROLLER USER MANUAL
Key
In settings menu, confirm the set value.
1. Return to the first screen;
2. In settings menu return to previous level menu.
and simultaneously and genset can be forced to start. At this time,
Fig. 1 - Controller Front Panel
Table 6 - Alarm Indicators
Indicator off
Slow flashing(1time/s)
Slow flashing(1time/s)
Fast flashing(5 times/s)
Fast flashing(5 times/s)
2020-02-20
Description
Alarm Indicator
Version 1.0 Page 13 of 69