Smartgen HGM8110DC-2 User Manual page 39

No. Items
7 IP Set
Scheduling And Maintenance Setting
1 Scheduled Run
2 Maintenance
Scheduled Not
3
Run
Analog Sensor
Temperature Sensor
1 Curve Type
Open Circuit
2
Action
3 High Shutdown
4 High Warning
5 Low Warning
HGM8110DC-2 Genset Controller
HGM8110DC-2 GENSET CONTROLLER USER MANUAL
Parameters Defaults
(0-1) 1
(0~1) 0
(0~1) 0
(0~1) 0
(0~15) 9
(0~2) 0
0: Disable
1
1: Enable
(0~300)º C 98
(0-3600)s 3
0: Disable
1
1: Enable
(0~300) º C 95
(0~300) º C 93
(0-3600)s 5
0: Disable
0
1: Enable
(0~300)º C 70
(0~300)º C 75
(0-3600)s 5
2020-02-20
Description
0: Disable 1: Enable
All the settings about Ethernet (such as IP
address and subnet mask) will active after
the next time power on.
0: Disable; 1: Enable
0: Disable; 1: Enable
0: Disable; 1: Enable
SGD See Table 16.
0: Warning;
1: Shutdown;
2: No action
Start to detect alarms when it is enabled;
not detect alarms when disabled;
When external temp. sensor value is
above this value, temp. high shutdown
alarm is issued. It is detected only after
Safety On Delay is over.
Alarm starts when temp. reaches alarm
value and this delay time is expired.
Start to detect alarms when it is enabled;
not detect alarms when disabled;
When external temp. sensor value is
above this value, temp. high warning alarm
is issued. It is detected only after Safety On
Delay is over.
When temp. high warning is active, temp is
below return value, alarm can be cleared
automatically.
Alarm starts when temp. reaches alarm
value and this delay time is expired.
Start to detect alarms when it is enabled;
not detect alarms when disabled;
When external temp. sensor value is below
this value, temp. low warning alarm is
issued. It is detected only after Safety On
Delay is over.
When temp. low warning is active, temp. is
above return value, alarm can be cleared
automatically.
Alarm starts when temp. reaches alarm
Version 1.0 Page 39 of 69