Detroit Diesel Ddec Iii / Iv; Deutz Emr2; John Deere - Smartgen HGM8110DC-2 User Manual

Engine type: Common J1939

14.8 DETROIT DIESEL DDEC III / IV

Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Common J1939

14.9 DEUTZ EMR2

Terminals of controller
Fuel relay output
Start relay output
-
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4

14.10 JOHN DEERE

Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: John Deere
HGM8110DC-2 Genset Controller
HGM8110DC-2 GENSET CONTROLLER USER MANUAL
Table 31 - Engine CAN Connector
CAN port of engine
Expand 30A relay, battery
voltage of ECU is supplied
by relay.
-
-
CAN(H)
CAN(L)
Table 32 - F Connector
F connector
Expand 30A relay, battery
voltage of 14 is supplied
by relay. Fuse is 16A.
-
1
-
12
13
Table 33 – 21-Pin Connector
21 pins connector
G,J
D
-
V
U
2020-02-20
Remark
Connect to starter coil directly.
CAN communication shielding line
(connect with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connect to starter coil directly.
Connect to battery negative pole.
CAN communication shielding line
(connect with controller's terminal only).
Impedance 120Ω connecting line is
recommended.
Impedance 120Ω connecting line is
recommended.
Remark
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.0 Page 63 of 69