Omron OMNUC W Series User Manual page 289

Ac servomotors/servo drivers
Hide thumbs Also See for OMNUC W Series:
Table of Contents

Advertisement

Operation
4-5-5
Switching the Control Mode (Switching Control)
H Functions
• This function controls the Servomotor by switching between two control modes by means of external
inputs.
• The control mode switching is executed at the control mode switching control input terminal (TVSEL:
CN1-41).
Controller
H Parameters Requiring Settings
Parameter
Parameter name
No.
Pn000.1
Function selection
basic switch 1
Control mode
selection
Pn50C.3
Input signal
selection 3
TVSEL signal
selection
Note If you select the switching control mode with the default settings, the mode will be allocated to pin
CN1-41.
If changing the default setting, set Pn50A.0 (input signal selection mode) to 1 (user-defined set-
tings).
H Related Functions
Note Refer to the related functions for each control mode.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
OMNUC W-series Servo Driver
Analog voltage
(speed command)
(Example: Between position
control and speed control)
Pulse train
Select control mode for switching control (Settings:
7, 8, 9)
You must set Pn50C.3 (TVSEL signal selection).
(See note.)
Switching control
Speed control
Position control
Explanation
Chapter 4
OMNUC W-series
Servomotor
Reference
4-4-3 Important
Parameters
4-4-3 Important
Parameters
4-73

Advertisement

Table of Contents
loading

Table of Contents