Omron OMNUC W Series User Manual page 243

Operation
Parameter Parameter
Para- Para-
name name
meter meter
Digit
No. No.
No.
Pn50A Input 0
signal
selection 1
1
2
3
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Explanation (See note 1.)
Name Set- Explanation (See note 2.)
ting
Input
0 Sets the sequence input
signal signal allocation to the same
allocation as R88D-UT.
mode d
1 User-defined sequence
input signal allocation
RUN 0 Allocated to CN1, pin 40:
signal g Valid for low output.
(RUN (RUN
1 Allocated to CN1, pin 41:
comman
Valid for low output
d) input d) input
2 Allocated to CN1, pin 42:
terminal
allocation Valid for low output
3 Allocated to CN1, pin 43:
Valid for low output
4 Allocated to CN1, pin 44:
Valid for low output
5 Allocated to CN1, pin 45:
Valid for low output
6 Allocated to CN1, pin 46:
Valid for low output
7 Always enabled.
8 Always disabled.
9 Allocated to CN1, pin 40:
Valid for high output
A Allocated to CN1, pin 41:
Valid for high output
b Allocated to CN1, pin 42:
Valid for high output
C Allocated to CN1, pin 43:
Valid for high output
d Allocated to CN1, pin 44:
Valid for high output
E Allocated to CN1, pin 45:
Valid for high output
F Allocated to CN1, pin 46:
Valid for high output
MING 0 to Same as Pn50A.1.
signal F
MING (gain reduction)
input
signal allocation
terminal
allocation
POT 0 to Same as Pn50A.1
signal F
POT (forward drive
Input
prohibited) signal allocation
terminal
allocation
Default Default Default Default Unit Unit
setting setting setting setting
100/200 V 100/200 V 400 V 400 V
8100 2100 ---
Chapter 4
Setting Setting Restart Restart
range range power? power?
--- Yes
4-27