Floppy-Drive Interface; Connector (X13) - Kontron MOPSlcdGX1 Product Manual

MOPSlcdGX1 Product Manual

12. FLOPPY-DRIVE INTERFACE

The floppy-drive interface can support one 3.5" drive, using the adapter cable ADA-
Floppy 2, (Kontron Embedded Modules part number 96001-0000-00-0).
The board can support the following drive capacities:
• 720K
• 1.44M
• 2.88M
For more information on floppy-drive interfaces, please see the
and Standards chapter.

12.1 Connector (X13)

To find the location of Connector X13 on the MOPSlcdGX1 board, please see the
Appendix E: Connector Layout
Signal Function
VCC (*) + 5V
VCC (*) + 5V
VCC (*) + 5V
NC -
NC -
NC -
NC -
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
(*)To protect the external power lines of peripheral devices, make sure that:
Note:
- wires have the right diameter to withstand the maximum available current
- the enclosure of the peripheral device fulfils the fire protecting requirements of
IEC/EN 60950.
Kontron Embedded Modules
chapter.
Pin Signal Function
2 IDX Index
4 DS0 Drive select 0
6 DCHNG# Disk change
8 NC -
10 Mo0 Motor on
12 DIR Direction select
14 STEP Step
16 WD Write data
18 WG Write gate
20 TR00 Track 00
22 WP Write protect
24 RD Read data
26 SIDE Side one select
22
Floppy-Drive Interface
Appendix G: Literature
Revision 1.3