Table of Contents
Advertisement
Do not use a screwdriver to tighten the screw.
CAUTION:
CAUTION:
Do not twist the cable service loop during installation.
NOTE:
NOTE:
The PCIe riser cage is not shown in this illustration for clarity purposes.
8. Install the access panel.
9. Slide the server into the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
13. Admit the new DSC-25 card to the Pensando Policy and Services Manager (PSM).
For more information, see Pensando Distributed Services Card for Single-Wire Management (DSC-25-SWM) Removal/Replacement
Guide on the Hewlett Packard Enterprise website (https://www.hpe.com/support/dsc25-replacement
https://www.hpe.com/support/dsc25-replacement).
Replacing the Pensando DSP DSC-25 2p SFP28 card with the iLO Sideband ALOM Module
128
Advertisement
Table of Contents
Troubleshooting
