Removing And Replacing The Boot Device - HPE ProLiant DL360 Maintenance And Service Manual

Removing and replacing the boot device

Removing and replacing the boot device
Prerequisites Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit.
T-10 Torx screwdriver.
Procedure Procedure
1. Observe the following alerts:
CAUTION: CAUTION:
The boot device and the drives installed on the boot device are not hot-pluggable. To remove the boot device, or a
drive from the boot device, you must first power down the server.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the PCIe riser cage, if necessary.
9. Remove the boot device.
10. Remove the drives from the boot device.
Removing and replacing the boot device 130