7.25 Counts the progress time
[Explanation]
Progress time is counted according to conditions. The counted time can be outputted as a value, if
"PASS function" is used.
(Refer to Section 2.3 of "PARAMETER LOADER INSTRUCTION MANUAL" for "PASS
function".)
Note: When the recorder is in recording, the setting cannot be changed.
[Operation]
Select the Others key
Progress time
①
ON/OFF of a progress time display is chosen. If it selects "ON", it will be displayed on the lower
of the clock display part of a realtime trend screen. (Refer to Section 6.1 for clock display.)
Even if "OFF" is chosen, when conditions are fulfilled, progress time counts.
Condition
②
The conditions which start or stop the count of progress time are chosen.
※When a count is stopped and it starts again, a count is started after resetting a value.
Record:A count of progress time is started when record is started, and a count is stopped when
record is stopped.
Alarm:A count of progress time is started when alarm occurs, and a count is stopped when
alarm recovered.
DI
:A count of progress time is started when DI is ON, and a count is stopped when DI is OFF.
CH No. / DI No.
③
This item can only be set when the "
CH number or DI number used for "
Alarm No.
④
This item can only be set when the "
Alarm number used for "
Manual reset
⑤
The count of progress time is reset by manual operation.
※ "All" in the selection item of CH number and alarm number means the thing of all the CH
number and alarm number.
Ex) CH number is "CH01", Alarm number is "All".
A count of progress time is started when an alarm occurs in either of "alarm number 1
of "CH 01". Moreover a count is stopped when an alarm recovered all of "alarm number 1
4" of "CH 01".
Progress time key on the Parameter.
⇒
Condition" is "Alarm" or "DI".
②
Condition" is set up.
②
Condition" is "Alarm".
②
Condition" is set up.
②
7-36
①Progress time
②Condition
③CH No. / DI No.
④Alarm No.
⑤Manual reset
4"
~
~
Need help?
Do you have a question about the TRM20A and is the answer not in the manual?