Toho Electronics TRM20A Operation Manual page 53

Output
③
The warning units relay number of the option is specified, and the warning output destination is
set. The selection item changes by connecting the relay and the transistor.
Common : The main body has been equipped normally.
Transistor: When the "DI/DO card (Option)" is selected, can be set.
Alarm value
④
This item cannot only be set when the "
The alarm value is set.
The decimal point position of the alarm value can be changed by changing the value of Scaling
key Decimal point key. (Refer to Section 7.6 for Decimal point key.)
⇒
OK, Cancel key
⑤
The each setting for changing contents is saved by the OK key. And, the "Parameter" can be
returned not change by the Cancel key.
No selected range
⑥
The gray color is displayed that cannot be selected now. In this case, can be selected by presses
OK key (or Cancel key) returning to "Parameter".
Alarm type" is "Fault".
②
7-16