Parameter Log File - Toho Electronics TRM20A Operation Manual

10.19 Parameter log file

File that contains information about parameters set in the past. This file is internally generated for example
when you select the input type. The parameter log file is not generated when an operation not related to
parameters (such as start of recording) is performed.
The recorder contains information about up to 50 past parameters. When 50 or more parameter log files are
recorded, the oldest file is overwritten and updated.
When you setting parameter, a parameter file associated with security logs is recorded. This parameter file
is output to the SD card with measurement data when recording stops. When the SD card contains the same
parameter file, that parameter file is neither saved nor overwritten. The created parameter file can be
checked using the support software (parameter loader).
[Output method]
When extended security mode is disabled：・Touch the Log output key. (For log output, see Section 8.6)
When extended security mode is enabled：・Touch the Log output key. (For log output, see Section 8.6)
[Output destination]
・When the Log output key is touched
The log is output to the "Prm_YYMMDD_hhmmss" folder in the "Recorder" folder.
・When recording stop (only when extended security mode is enabled)
The log is output to the "Prm" folder in "Recorder / EXSEC_ XXXXXXXXXX (Serial number)".
File name: nnn_YYMMDD.dps
Extension: dps
・When recording stops. It is output at the same timing as the
recording data.
Naming conventions of parameter log file
Folder name: nnn_YYMMDD (when recording the
parameter file)
YY: Two-digit year (00 to 99)
MM: Two-digit month (01 to 12)
DD: Two-digit day (01 to 31)
nnn: Three-digit security logs number (000 to 999)
10-15