Setting The Alarm Value - Toho Electronics TRM20A Operation Manual

7.9 Setting the alarm value

［Explanation］
When abnormality occurs in measurements recording, warning is occurred. Moreover, the warning
units relay number of the option is specified, and the warning output destination is set.
［Operation］
Select the Input CH key
⑥No selected range
Channel No.
①
The set channel is selected. (The selection range becomes CH13
Alarm type
②
ON/OFF of the alarm function and the warning type are set.
HI : When measurements exceed a set value, warning is occurred.
LOW : When measurements fall below compared with a set value, warning is occurred.
Fault : Warning is occurred at "H over", "L over", "Burn out", "INVALID", and
"Abnormal input".
Alarm value key on the Parameter.
⇒
CH48 in the "Calc. CH.".)
～
7-15
①Channel No.
②Alarm type
③Output
④Alarm value
⑤OK, Cancel key