Architraves - Access 7000 Installation Manual

ASSEMBLY
4
The inner beams are to end evenly alongside
the inner guides. There are inner beams in
every second rear beam

5.7.2 ARCHITRAVES

1
Assemble architraves in the order shown in the
illustration.
2
Always start with the architrave that has an
opening for the electrical cabinet. The position
of the opening should be 50 mm above the low-
ering crank. See pos A.
3
The joints of the architrave is connected on the
front side with pop-rivets and square washers
and on the back side with installation screw
4.2x14 and square washers. Fixate the archi-
trave from the inside of the inner beam.
4
Fixate the architrave into the inner beam of the
mast. See pos B.
5
Continue with full height architraves down to
the pit. Finnish by cutting the last architrave
pos 3.
6
Continue with architraves from the electrical
cabinet up to the top, finish according to instal-
lation drawing by cutting the last architrave.
7
Assemble architraves on the opposite side in
the order shown in the illustration.
8
Start with a full height architrave, build up to
the top, finish according to installation drawing
by cutting the last panel.
9
For half height door on upper level see chapter
6.9 DOOR TYPE HG, HALF SIZE DOOR.
58
Fig. 43 Inner beam ends
Fig. 44 Architraves
7000 100 en-GB AD