Installing Outer Roof - Access 7000 Installation Manual

OPTIONS

6.2.7 INSTALLING OUTER ROOF.

Note:
Use roof screws with rubber gasket when assembling the outer roof.
• The shaft, architrave and the mast should stop 2280 mm from the top floor, 60 mm over the end of
the top door.
• Remove the angel profile 13042 at the top of all doors.
• Mount the ventilation fan (x2) on the inside cladding panel 10156 and connect the fan to separate
power. Use Inside cladding panel 10056 if no ventilation fans are mounted.
• Mount the door cap 11234 at the top of the door if necessary.
• Profile 10121 shall be mounted together with the Door cap
• Mount the profile 10119 (3 pcs.) around the inside at the shaft, the profile should have same level as
the door profile 10121.
The ventilation holes in the profile 10119 shall be up.
• Place the three pieces of inner ceiling, 10069x2 and 10053 or 10185 (for LED-light) in position.
• Lock the ceiling with the profile 10110 in the front of the door.
108
7000 100 en-GB AD