Adjust The Platform - Access 7000 Installation Manual

Fig. 37 Adjust the lifting yoke
CAUTION
All four guide shoes are to touch - do not press in the bottom of the guides. Pressing
the guides affects the distance between the guide rails.
Note:
The distance between the lifting yoke and the guide rail frames are to be the
same on the left and right sides, at the top and bottom of the yoke.
• Tighten the nuts to lock the screws.

5.5.3 ADJUST THE PLATFORM

The level of the platform is not adjusted from the factory. If the platform not is in level this can cause in-
correct load on the driving nut.
• Use a water level to check that the platform is horizontal. If necessary, press down the "upper side"
until the platform is in level (horizontal).
• Adjust the platform until it is centered between the guides. See Fig. 38 Horizontal check and center-
ing check. Check by measuring the distances between the outer guides and the platform on the Left
and Right sides.
7000 100 en-GB AD
ASSEMBLY
55