Adjust The Lifting Yoke - Access 7000 Installation Manual

ASSEMBLY
• If an adjustment is needed, release the screws a half turn and adjust the rail, see the picture. Fix with
clamps before tighten the screws.
Fig. 36 Joint level adjustment
• Recheck the distance between the rails after the adjustment.
• Check, adjust and lock the screws at each joint every 1250 mm.
• Lock the resistent screws.

5.5.2 ADJUST THE LIFTING YOKE

Adjusting the position of the lifting yoke is important, incorrect adjustment will cause noise and
vibrations.
• Adjust the lifting yoke until it is centered between the guide rail frames. See Fig. 37 Adjust the lifting
yoke. Use the four guide shoes to make the adjustment
54
7000 100 en-GB AD