Adjustments; Adjust The Guide Rail Frames - Access 7000 Installation Manual

ASSEMBLY
Fig. 33 Flat cable strapping

5.5 ADJUSTMENTS

CAUTION
The adjustments described in this chapter is very important for further installation and
to make the lift run smooth and quiet.

5.5.1 ADJUST THE GUIDE RAIL FRAMES

Before the adjustment of the rail guides the four guide shoes shall be loose, not press in the bottom
of the rail guides.
The procedure is; moving on the platform from top to bottom, or vice versa, check distance and if the
joints are smooth. If adjustments are necessary, release all the screws and adjust the distance and
smoothness at every joint. Tighten the screws when all the mast has correct distance and smooth joints.
The adjustment
• Check the distance between the guide rail framed from top to bottom, it is to be 800 ± 2 mm and
make sure that the insides of the guide rail frames are even at every joint. See Fig. 34 Check and ad-
just the guide rail frames
52
7000 100 en-GB AD