Automatic Lubrication; General; Installation - Access 7000 Installation Manual

OPTIONS

6.8 AUTOMATIC LUBRICATION

6.8.1 GENERAL

Automatic lubrication is an option for lifts with a lower travel than 8 meter. For lifts over 8 meters it is
included in the standard delivery.

6.8.2 INSTALLATION

• The tank for the automatic lubrication is delivered in a separate box. At installation it has to be
mounted at the top of the mast. The tank is fastened with Velcro, the blue hose shall be connected
to the tank-outlet, adjust the length so the hose stops close to the driving-screw. Connect the electri-
cal wires shall be connected to the pump (cables are interchangeable)
• Fill the plastic container in the top of the mast with oil. See Fig. 144 Automatic lubrication. Fill the
container with oil until it is 1 centimeter left to the edge of the container, see pos 1.
Fig. 144 Automatic lubrication
• The hose shall be flushed against the screw according to Fig. 144 Automatic lubrication.
• Make the oil lubrication settings on the U1 board with the dip switches. See Fig. 145 DIP switch
setting for oil lubrication on U1 control board.
122
7000 100 en-GB AD