Table of Contents
Advertisement
ASSEMBLY
Fig. 38 Horizontal check and centering check
Note:
When doing this do not stand on the platform ( if it is possible to avoid).
• Tighten the eight screws between platform and yoke.
5.6 ASSEMBLY THE SAFETY FRAME
5.6.1 SAFETY EDGE
1
Put the safety edge through the holes in the
top of the platform frame.
2
Check that the "sliding area" is clean and
lubricated.
3
Hook the spring (see pos 1, Fig. 39 Safety edge),
and fasten the nut and washer (see pos 2, Fig.
39 Safety edge)
4
Tighten the two nuts so that the safety edge
works properly.
5
Check the function of the safety switch, it shall
stop the lift (cut the circuit) when pressed 5
mm.
6
Adjust the switch if necessary.
5.6.2 SAFETY FRAME
1
Put the safety frame in place around the
platform.
56
Fig. 39 Safety edge
7000 100 en-GB AD
Advertisement
Table of Contents
