Shaft Construction; Shaft Beam - Access 7000 Installation Manual

2
Lift the ends of the wires, slide them into the
safety edge about 50 mm and lock with screws.
See pos 1.
3
Fasten the safety frame with the two pairs of
screws under the platform on the left and right
side.
4
Adjust the position of the safety frame side-
ways before locking the two pairs of screws.
5
The distance between platform and safety
frame is to be 1-2 mm all the way around, ad-
just with screws under the platform.

5.7 SHAFT CONSTRUCTION

5.7.1 SHAFT BEAM

1
Slip in the shaft beam in the mast top (see pos
1,), fasten it with 2 pcs of screw tapping M6x16
FZ and nut M5.
2
Mount the shaft brackets (2 pcs) with 2 pcs of
screw tapping M6x16 FZ (see pos 2).
3
Release the inner beams (4 pcs of screw tap-
ping M6x16 FZ) and pull them out. See pos 3.
Fig. 40 Safety frame
Fig. 41 Fasten the safety frame
Fig. 42 Shaft beams in the mast
7000 100 en-GB AD
ASSEMBLY
57