Safety Frame On The Platform Floor - Access 7000 Installation Manual

• Loosen the side cover (pos 3 Fig. 7 Material preparations, positioning) from velcro closing (pos A, Fig.
9 Dismounting side cover panels, details) at the bottom of the platform by pulling it outwards from
the platform (pos A, Fig. 9 Dismounting side cover panels, details)
Fig. 9 Dismounting side cover panels, details
• Unhook the side cover from the screw (pos B, ,Fig. 8 Dismounting side cover panels) at the bottom of
the platform by sliding it towards the platform centre (pos B, Fig. 9 Dismounting side cover panels,
details).
• Unhook the side cover at the top of the platform (pos C, ,Fig. 8 Dismounting side cover panels) by
moving it outwards from the platform and downwards (pos C, Fig. 9 Dismounting side cover panels,
details).
• Follow the same procedure with the side cover on the other side (pos 4, Fig. 7 Material preparations,
positioning) of the platform (mirror-inverted).

3.8.4 SAFETY FRAME ON THE PLATFORM FLOOR.

• Push over the platform
Fig. 10 Safety frame and safety edge dismounting
• Loosen the screws on the safety edge's ends (left and right sides, pos 1, Fig. 10 Safety frame and
safety edge dismounting). Slide the wires outwards.
• Remove the two pairs of screws under the platform's outer corners (pos 2, Fig. 10 Safety frame and
safety edge dismounting).
• Lift off the safety frame (pos 5, Fig. 7 Material preparations, positioning) and the wires in one piece.
RECEIPT OF MATERIAL ON SITE
7000 100 en-GB AD
13