Assembly The Mast, Platform And Driving Unit; General; Joining The Mast Sections - Access 7000 Installation Manual

ASSEMBLY
All fixings are delivered with the lift. The number of fixings depends on travel height and execution.

5.2 ASSEMBLY THE MAST, PLATFORM AND DRIVING UNIT

5.2.1 GENERAL

Important
Assemble the mast and platform is a work that requires accuracy and patience. The lit-
tle extra time spent on these adjustments is well invested and makes the lift run
smooth, quiet and without vibrations. The longer lift the more careful you have to be.
Observe that the mast and platform only are coarse adjusted from the factory.
The following steps guides you to the important operations (observe that the steps sometime can be
done in different order depending on installation location).
All steps are important before starting to build the shaft:
1. Plumb and adjust the raised mast/rail frames.
2. Adjust the distance between the guide rail frames and adjust the guide rail joints. See 5.5.1 ADJUST
THE GUIDE RAIL FRAMES.
3. Adjust the lifting yoke in centre of guide rails (the mast). See 5.5.2 ADJUST THE LIFTING YOKE
4. Adjust the platform horizontal level and centered. See 5.5.3 ADJUST THE PLATFORM.

5.2.2 JOINING THE MAST SECTIONS

The mast is, at delivery, normally divided in several 2235 mm-sections witch shall be joined to the com-
plete mast. If the mast is delivered as one piece this chapter can be skipped.
The mast consists of 3 different sections:
• One bottom section.
• A number of, depending on the mast length, middle sections.
• One top section, usually shorter than 2235 mm.
• Place (if possible) the mast sections as the picture show. The top section closest to the wall, then the
middle sections and furthest from the wall the bottom section.
20
7000 100 en-GB AD