Screw Joint - Access 7000 Installation Manual

OPTIONS
or manual lowering system. Tighten the allen
screw when it is in the right level.
Tip! The belt disc shall rotate freely from the final
limit switch with a distance of 1-2 mm
Tip! To simplify the installation procedure it is possi-
ble to wait to connect the belt until the platform is
connected to the driving unit.
• Mount the belt according to the illustration (the
figure shows manual lowering). Be sure that the
belt is below the guide roller (pos 1). Tighten the
belt by rotating the screws (pos 2. The belt shall
not slide.
If electrical lowering the tension of the belt is
automatic.
• Mount the safety stop bracket (part no. 10 111),
see pos 3, on the top of the mast.

6.3.2 SCREW JOINT

Before installation control the following:
1
Control that the screw joint is numbered ac-
cording to the label and the punched marking
in the bottom of the thread of the screw, see il-
lustrations below
2
Control that the threading is whole and clean
and that there is no damage.
110
Fig. 118 Mount the belt
Fig. 119 Punched marking –screw joint
Fig. 120 Screw joint identification example
7000 100 en-GB AD