Table of Contents
Advertisement
6 - Maintenance
Feed Pipe Clamp Assembly
Remove a feed pipe from the pipe clamps the following way:
1. Use a flat bladed screwdriver to prize the cover off the first corner (A).
2. Hold the clamp top with your hand and prize off the opposite
corner (B) with the screwdriver.
3. Prize off the other side of the pipe clamp with the screwdriver.
4. Take out the feed pipe.
Nozzle Holder Assembly
If leaks of fluid occur in the nozzle holders on the spray boom, it is necessary to check the sealing. To locate the gaskets
disassemble the nozzle holder.
Recommendation is occasional maintenance of the gaskets and nozzle holders.
Usually is poor sealing caused by:
• Missing O-rings.
• Damaged or incorrectly seated O-rings.
• Dry or deformed O-rings.
• Foreign objects.
In Case of Leaks
Disassemble the nozzle holder and check condition of the O-rings. Replace, if damaged or cracked.
Disassemble Nozzle Holders
1. Example of an assembled nozzle holder, fitted to the spray boom.
170
Advertisement
Table of Contents
