Table of Contents
Advertisement
5 - Operation
11. Engage the hopper transfer device by opening the TurboFiller
suction valve (C) to transfer chemicals to the MainTank.
12. Measure the correct quantity of chemical and fill it into the hopper.
€
DANGER! Always wear face shield and other appropriate personal
safety equipment, when filling chemicals.
μ
ATTENTION! Only use the scale in the hopper, when parking the
sprayer on level ground! Recommended is to use a measuring jug
for best accuracy.
13. The TurboFiller suction valve (C) must be open for at least 20
seconds after the chemical is no longer visible in the hopper, in order to empty the transfer hoses completely into the
MainTank.
€
DANGER! If the TurboFiller and the transfer hoses not completely emptied, there is a risk of chemicals flowing back
into the hopper!
14. Enable the push-activated chemical container-rinsing nozzle (D),
by lifting the lever up.
15. Place the container over the chemical container-rinsing nozzle (D)
in the left side of the TurboFiller. Then push down to rinse the
inside of the container.
μ
ATTENTION! The rinsing device uses spray liquid to rinse
containers for concentrated chemicals. Before disposal, always
rinse the chemical containers with clean water several times, until
they are clean.
16. Close the TurboFiller lid.
17. When reaching the MainTank quantity entered, the filling process
automatically stops.
18. When amount filled reached, AutoFill automatically set agitation to 100%.
μ
ATTENTION! If foaming is a problem, reduce the agitation level.
19. If foaming is a problem, press
20. Press
to enter the agitation menu.
75
50
21. Press
%
%
,
22. Press
to leave the AutoFill or Agitation menu.
23. Press
to enter the Fluid Functions menu.
24. Press
to enable suction from the RinseTank or press
122
to leave the AutoFill menu.
25
OFF
%
,
or
to set at a suitable agitation level.
to enable suction from an external tank.
Advertisement
Table of Contents
