Table of Contents
Advertisement
External Filling Device without AutoFill
The following describe use of the External Filling Device without the AutoFill program:
1. Remove the cap for
suction coupler.
2. Press
to enable filling to "MainTank".
3. Press
to enter the agitation menu.
4. Press
OFF
to close the agitation valve.
5. Engage the pump and set PTO revolutions at max. 540 RPM or
1000 RPM depending on pump model.
6. Press
to enable suction from an external source, using the
"External Filling Device".
€
DANGER! Prevent contamination or injury. Do not press
connected. If pressed without the pump running, liquid will stream out of the coupler.
7. Keep an eye on the window (A) in the display
for filling status.
8. Press
on the FluidBox to discontinue
the filling process. Now disengage the pump.
9. Disconnect the suction hose and replace the
cap.
±
WARNING! Do not leave the sprayer while
filling the tank, and keep an eye on the level
indicator in order NOT to overfill the tank.
±
WARNING! If carrying the suction hose/filter
on the sprayer during spraying, spray drift
can contaminate it, which will transfer to
lake/river when filling!
μ
ATTENTION! Observe local legislation regarding use of filling device. In some areas, filling from open water reservoirs
(lakes, rivers etc.) prohibited. It is strongly recommended only to fill from closed reservoirs (mobile water tanks etc.)
to prevent contamination.
and connect a suction hose to the
, unless the pump is running and the filling hose is
3,5
b
540
rpm
A
50
5000
%
l
5 - Operation
250
l
115
Advertisement
Table of Contents
