Hardi AEON CENTURA TWIN FORCE Instruction Book page 142

5 - Operation
3. Prepare sprayer for cleaning. Fill water in the MainTank to 10% of its capacity. Fill the RinseTank completely. Later this
water is used for rinsing.
4. Add the cleaning agent to the MainTank by using the TurboFiller. Follow instructions on the label of the cleaning agent.
5. Press
to enable suction from MainTank and press
6. Press
to enter the agitation menu.
7. Press
100
to fully open the agitation valve.
%
8. Engage and set the pump speed at approximately 300 RPM. Also, engage auxiliary FlexCapacity pump, if available.
9. Allow the liquid to circulate the system for 3 minutes.
10. Press
to activate the ejector for minimum 10 seconds, without activating the TurboFiller functions in order to
burst and flush the safety valve.
11. Open the TurboFiller suction valve
12. Close the TurboFiller lid and press the hopper cleaning lever
13. Close all three valves on the TurboFiller again.
14. Verify that all nozzles are closed on the main valve ON/OFF switch
(A) on the Grip.
15. On the FluidBox, press
16. Allow the liquid in the MainTank to circulate for minimum 3
minutes with the nozzles closed. This is done to clean the return
lines from boom to tank.
17. Press
to enable the tank cleaning nozzles. Allow the liquid
to circulate for 3 minutes.
18. Spray out water with cleaning agent and chemical residue.
Set the spray pressure at 3-5 bar.
Note that the washing water still contains active chemical and choose an appropriate area to spray this out.
Alternatively, the washings can be dumped at the filling/washing location and retained in an appropriate receptacle
(e.g. slurry tank or similar). Prevent spot contamination and accumulation.
Continue to spray until all liquid has exited from the boom pipes and nozzles.
19. Close all nozzles with the main ON/OFF switch.
20. Rinse the sprayer again with clean water to rinse out all remains of the cleaning agent. This prevents the cleaning agent
remaining in the fluid system, which could damage the next spray chemical filled into the MainTank.
21. Include rinsing of the TurboFiller in step 18. Operate all 3 valves during this process.
22. Disassemble all filters (suction, pressure, in-line and nozzle filters) and clean the filter screens using clean water and
detergent and a brush.
±
WARNING! It is the responsibility of the sprayer operator or owner, to clean the sprayer sufficiently to prevent
contamination of the environment, crop damage and health and safety hazards to the operator and the public. Any
damage or incidents related to insufficient cleaning cannot be HARDI's responsibility.
μ
ATTENTION! The rinsing nozzles cannot always guarantee a 100% cleaning of the tank. Clean manually with a high
pressure cleaner afterwards, especially if the next crop is sensitive to the chemical just sprayed!
142
and the TurboDeflector valve
to enable spraying.
to enable return to the MainTank.
. Allow the liquid to circulate for 3 minutes.
to clean the hopper inside.
A