Sprayer Setup; General Info; Unloading The Sprayer; Before Putting The Sprayer Into Operation - Hardi AEON CENTURA TWIN FORCE Instruction Book

Table of Contents

To unload the sprayer, you need a crane.When unloading the sprayer with a crane, please observe the lifting points, and

make sure that the straps or belts used for lifting can handle the load.

€

DANGER! Lifting of machines require special training according to national regulations.

ATTENTION! Only lift the sprayer with empty tanks!

Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the

factory, it is recommended to apply a film of anti-corrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal

parts in order to avoid chemicals and fertilizers discolouring the paint or surface-treated parts.

If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep

the paint or surface-treated parts clean for many years. This treatment should be carried out every time the protection film

is washed off.

The hydraulic support leg is activated via a separate hydraulic outlet on the tractor. Connect the hydraulic hoses from the

support leg to the tractor and test the function of the support leg carefully.

1. Attach the sprayer to the tractor prior to raise or lower the support

leg.

• Retracted position (A), when already attached to tractor.

• Support position (B), when the sprayer stand on the

support leg.

2. If retracted (A), pull the lock (C) to unlock the support leg from its

storing position.

3. Turn the lever to unlocked position

hydraulics.

4. Use the tractor hydraulic lever to raise or lower the support leg.

5. Secure the support leg by turning the lever to position

€

DANGER! Always double check that the lever is in the locked

position

when leaving the sprayer standing on the support

leg.

to unlock the support leg

4 - Sprayer Setup

Table of Contents