Hardi AEON CENTURA TWIN FORCE Instruction Book page 127

11. Set the agitation valve as required:
100
A fully open agitation valve will result in very little suction capacity from the TurboFiller.
%
Preferred when agitation is necessary for mixing very dense chemicals, while transferring from the
75
%
TurboFiller.
50
%
Preferred when agitation is necessary for mixing, while transferring chemicals from the TurboFiller.
Preferred when transferring the powder into the tank requires more suction from the TurboFiller, but
25
%
mixing does not require much agitation.
A fully closed agitation valve will result in no agitation, while transferring the powder into the tank,
OFF
resulting in poor mixing.
μ
ATTENTION! Changing the suction restrictor for the TurboFiller, may be necessary for increased suction capacity from
the TurboFiller. Contact your HARDI dealer for further advice.
12. Open the TurboFiller lid.
13. Open the TurboDeflector valve.
14. Engage the hopper transfer device by opening the TurboFiller
suction valve (C) to transfer chemicals to the MainTank.
15. Measure the correct quantity of powdered chemical and sprinkle
it into the hopper as fast as the transfer device can flush it down.
16. The TurboFiller suction valve (C) must be open for at least 20
seconds after the chemical is no longer visible in the hopper, in
order to empty the transfer hoses completely into the MainTank.
€
DANGER! If the TurboFiller and the transfer hoses not completely
emptied, there is a risk of chemicals flowing back into the hopper!
€
DANGER! Always wear face shield and other appropriate personal safety equipment, when filling chemicals.
17. Close the TurboFiller lid.
±
WARNING! Do not leave the sprayer while filling the tank. Keep an eye on the top window (B) in the display for filling
status.
18. When reaching the quantity entered, the filling process automatically stops.
19. When amount filled reached, AutoFill automatically set agitation to 100%.
μ
ATTENTION! If foaming is a problem, reduce the agitation level.
20. If foaming is a problem, press
21. Press
to enter the agitation menu.
to leave the AutoFill menu.
5 - Operation
127