Drain Valve Seal Replacement
If the MainTank drain valve leaks, change the seal and seat in the
following way.
€
DANGER! Do not enter the inside of the tank - it is possible to
replace all parts from the outside of the tank!
±
WARNING! Use eye / face protection mask, when dismantling the
tank drain valve!
1. Make sure that the tank is empty and clean.
2. Check that the valve is closed and the string loose.
3. Pull out the clip (A) and pull down the connecting piece (B).
4. Pull out the entire valve assembly.
5. Check cord and valve flap assembly (C) for wear, replace seal (D)
and reassemble.
6. Reassemble the valve using a new valve seat (E). Lubricate O-rings (F) before assembly.
7. Fit clip (A) again.
μ
ATTENTION! Check the valve function using clean water, before filling chemicals into the tank.
Feed Pipe Clamp Assembly
Remove a feed pipe from the pipe clamps the following way:
1. Use a flat bladed screwdriver to prize the cover off the first corner (A).
2. Hold the clamp top with your hand and prize off the opposite
corner (B) with the screwdriver.
3. Prize off the other side of the pipe clamp with the screwdriver.
4. Take out the feed pipe.
6 - Maintenance
137