Table of Contents
Advertisement
9. Installing Software
Disabling the Packing Mode
Click on the General Tab on the Control Panel.
1.
2.
The Networking option enables the Ethernet checkbox and sets Ethernet IP
and Port as below and then click Manager.
Enter the command PVER] to verify the current mode. Note that the equipment is now
3.
in packing mode.
128
vatech A9 has the Packing Mode built into the system to
prevent the unit from being damaged while shipping and
transporting. Since the mode is automatically turned on upon
shipping, the installer must disable the Packing Mode before
turning on the equipment.
The equipment does not operate even after the power is
turned on if the packing mode is not properly disabled.
vatech A9 (Model:PHT-30CSS)
Installation Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the PHT-30CSS and is the answer not in the manual?
Questions and answers