Connecting To Power; Turn-On Checkout; Figure 4.4 Connecting To Power - Rigol HDO1000 Series User Manual

4.3.2

Connecting to Power

The power requirements of the oscilloscope are 100-240 V, 45-440 Hz. Please use the
power cord provided in the accessories to connect the oscilloscope to the AC power
source, as shown in the figure below.
WARNING
To avoid electric shock, ensure that the instrument is correctly grounded.
4.3.3

Turn-on Checkout

After the instrument is connected to the power source, press the power switch
the lower-left corner of the front panel to power on the instrument. During the start-
up process, the instrument performs a series of self-tests. After the self-test, the
splash screen is displayed.
• Restart: Click or tap
reboot?" is displayed. Click or tap OK to restart the instrument.
• Shutdown:
-
-
-
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Figure 4.4 Connecting to Power

> Restart. Then a prompt message "Are you sure to
Click or tap > Shutdown. Then a prompt message "Are you sure to
shutdown?" is displayed. Click or tap OK to shut down the instrument.
Press the power switch
shutdown?" is displayed. Click or tap OK to shut down the instrument.
Press twice to directly shut down the instrument.
and a prompt message "Are you sure to
Quick Start
at
HDO1000 User Guide
13