Figure 4.5 Connecting The Passive Probe - Rigol DHO900 Series User Manual

Quick Start
After you connect the passive probe, check the probe function and probe
compensation adjustment before making measurements. For details, please refer to
Function Inspection
Connect the Logic Probe
1. Connect the output terminal of the logic probe to the digital channel input
terminal on the front panel of the oscilloscope in the correct direction, as shown in
the figure below.
2. Connect the other terminal of the logic probe to the signal terminal under test.
DHO900 provides the optional PLA2216 active logic probe. To cater to different
application scenarios, PLA2216 provides two methods to connect the signal under
test. For details, refer to
DHO900 User Guide
14

Figure 4.5 Connecting the Passive Probe

and Probe Compensation
PLA2216 Active Logic Probe User Guide .
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
.