Replacing The Fuse; Figure 4.5 Replacing The Fuse - Rigol HDO1000 Series User Manual

Quick Start
-
TIP
You can also click or tap
In this way, the instrument powers on once connected to power.
4.3.4

Replacing the Fuse

If you need to replace the fuse, please use the correct fuse (AC 250 V, T3.15 A; 5.2
mm×20 mm) and follow the steps shown below (see
1. Power off the instrument and remove the power cord.
2. Insert a small straight screwdriver into the slot at the power socket and pry out the
fuse holder gently.
3. Remove the fuse.
4. Insert the proper fuse into the fuse holder.
5. Re-insert the fuse holder into the power socket.
WARNING
To avoid electric shock, please make sure that the instrument is powered off and
disconnected from the power before replacing the fuse. Also, please make sure the fuse is
consistent with the required fuse rating.
HDO1000 User Guide
14
Press for three seconds to directly shut down the instrument.
> Utility > Setup and select "Switch On" in "Power Status" item.

Figure 4.5 Replacing the Fuse

Figure 4.5
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
).