Can Decoding (Optional); Signal Configuration; Figure 14.16 Can Decoding Menu - Rigol HDO1000 Series User Manual

14.6

CAN Decoding (Optional)

The oscilloscope samples the CAN signal at the specified sample position, and judges
each data point to be logic "1" or logic "0" according to the preset threshold level.
You need to specify the CAN signal type and sample position.
In the Decode menu, click or tap the drop-down button of Bus Type to select CAN,
then configure the parameters for CAN decoding.
Bus Status
Click or tap the Bus Status on/off switch to enable or disable the bus decoding.
Quickly apply trigger settings to decoding
Copy trig indicates applying the trigger settings to the specified decoding setting.
Click or tap Copy Trig to apply the trigger settings to the specified decoding setting.
14.6.1

Signal Configuration

Set the source and the threshold
• Click or tap drop-down button of Source to select the desired source. The
sources include CH1-CH4.
• Click or tap the input field of Threshold, and then use the pop-up numeric
keypad to set the threshold of the source channel. You can also use the
corresponding multipurpose knob to set the value.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Figure 14.16 CAN Decoding Menu

Protocol Decoding
HDO1000 User Guide
191