Rigol HDO1000 Series User Manual page 39

You can connect the instrument to an external display that has the HDMI interface
(e.g. monitor or projector) via this interface to better observe the waveform display
clearly. At this time, you can also view the waveforms on the LCD of the
instrument.
6. USB DEVICE
Connect the instrument to the PC via this interface. Then you can use the PC
software Ultra Scope to send the SCPI commands or use the user-defined
programming to control the instrument.
7. LAN
Connect the instrument to network via this interface. The instrument conforms to
LXI CORE 2011 DEVICE instrument standard. Its test system can be built quickly.
Then you can control the instrument through using Web Control to send the SCPI
commands to control the instrument. When update is available, you can perform
online upgrading for the system software of the instrument via the LAN interface.
8. AC Power Cord Connector
The power requirements of the instrument are 100 V to 240 V, 45 Hz to 440 Hz.
The maximum input power is no more than 500 W. Please use the power cord
provided in the accessories to connect the instrument to the AC power source.
9. Fuse
If you need to replace the fuse, use only the specified fuse.
10. Security Lock Hole
Use a standard PC/laptop lock cable to secure the oscilloscope to a work bench or
other location.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Quick Start
HDO1000 User Guide
25