Figure 8.29 Hex Format Setting - Rigol HDO1000 Series User Manual

• A&D: the oscilloscope searches for the specified address and data at the same
time, then triggers when both the address and data meet the conditions. After
this condition is selected, you need to set the sub-menu items such as Direction,
Bytes, AddrBits, Address, and Data. For the setting methods, refer to
descriptions in "Address" and "Data" conditions.
Trigger Mode
In Sweep, select Auto, Normal, or Single as the trigger mode. For details, refer to
Trigger Mode
Trigger Parameter Setting
You can refer to
Level Selection and Setting
After the trigger condition setting is completed, you need to adjust the trigger level
to correctly trigger the signal and obtain a stable waveform.
• Level A
Click or tap the input field of Level A to input the level of SCL with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob or
trigger level knob to set the value. For details, refer to descriptions in
Level
top of the screen.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Figure 8.29 Hex Format Setting

.
Noise Rejection
to set the noise rejection under this trigger type.
. The current trigger level is displayed in the trigger information label at the
Triggering the Oscilloscope
Trigger
HDO1000 User Guide
103