To Set Probe; Figure 5.2 Waveform Invert On/Off - Rigol HDO1000 Series User Manual

When the Invert function is disabled, the waveform is displayed normally; when
enabled, the voltage values of the displayed waveform are inverted, as shown in the
figure below. Inverting a waveform also changes the result of math function,
waveform measurement, etc.
TIP
When the Invert function is turned on, the trigger (e.g. Edge trigger, Pulse trigger, or Slope
trigger) edge or polarity will be changed.
5.8

To Set Probe

The analog channel of this oscilloscope supports passive probes. For detailed
technical information of the probes, please refer to the corresponding Probe User
Guide.
Click or tap the channel status label at the bottom of the screen. Then the menu
Vertical is displayed. Then click or tap Probe to enter the Probe setting menu, as
shown in the figure below.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
"Invert" Off
"Invert" Off

Figure 5.2 Waveform Invert On/Off

Vertical System
"Invert" On
"Invert" On
HDO1000 User Guide
45