Otto Bock AxonEnergy Integral 757B501 Instructions For Use Manual page 16

7.5 Opening the terminal device in an emergency
8 Legal information
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
8.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
8.3 CE conformity
Otto Bock Healthcare Products GmbH hereby declares that the product is in compliance with
applicable European requirements for medical devices.
The product meets the requirements of the RoHS Directive 2011/65/EU on the restriction of the
use of certain hazardous substances in electrical and electronic devices.
This product meets the requirements of the 2014/53/EU directive.
The full text of the regulations and requirements is available at the following Internet address:
http://www.ottobock.com/conformity
9 Technical data
Ambient conditions
Storage (with and without packaging)
Transport (with and without packaging)
Operation
Charging the battery
16
This safety function allows the Axon-Bus gripping component to be
opened regardless of the control signals present.
1) With the Axon-Bus prosthetic system switched on, press the char­
ging receptacle button and hold for approximately three seconds
until the Axon-Bus gripping component begins to open.
→ A pulsating beep sounds as it opens.
2) Releasing the button immediately stops the process of opening
the Axon-Bus gripping component and turns the entire Axon-Bus
prosthetic system off.
+5 °C/+41 °F to +40 °C/+104 °F
Max. 85% relative humidity, non-condensing
For reasons of quality (service life), it is recom­
mended that the product be stored at low tem­
peratures.
-20 °C/-4 °F to +60 °C/+140 °F
Max. 90% relative humidity, non-condensing
-5 °C/+23 °F to +45 °C/+113 °F
Max. 95% relative humidity, non-condensing
+5 °C/+41 °F to +40 °C/+104 °F
Max. 85% relative humidity, non-condensing