Using The Tuning Dial; Using The [Y]/[Z] Keys - Icom ID-880H Instruction Manual

2
BASIC OPERATION

Using the tuning dial

q Rotate [DIAL] to set the frequency.
• If VFO mode is not selected, push [VFO/MHz] to select VFO
mode.
• The frequency changes in the selected tuning steps. (p. 18)
[DIAL] [VFO/MHz]
w To change the frequency in 1 MHz
steps, push [VFO/MHz], then rotate [DIAL].
• Pushing and holding [VFO/MHz] for 1 sec. starts scan function.
If scan starts, push [VFO/MHz] again to cancel it.
14
While 10 MHz tuning step is selected,
the digit below 1 MHz disappear.
While 1 MHz tuning step is selected,
the digit below 100kHz disappear.
(10 MHz for some versions)

Using the [Y]/[Z] keys

Push [Y] or [Z] to select the desired frequency.
YZ
• Pushing and holding [Y]/[Z] for 1 sec. activates a
scan. If scan starts, push [Y]/[Z] or [
cancel it.
A(MW)] to
CLR