Installation Procedures - Cisco MGX MGX 8800 Hardware Installation Manual

Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Table 5-1 Installation Checklist—MGX 8850, MGX 8850/B, or MGX 8880 Systems (continued)
Rack-Mounted System
Check Steps (Without Lift)
Step 10 Install the Exhaust Plenum
Step 11 Install the DC PEM(s) as necessary
Step 12
Install the Cable Management Assembly
Step 13 Connect the Fan Tray Power Cables to the switch
Step 14 Connect the AC Power Supply Tray to the switch as necessary
Step 15 Connect the DC PEM to the switch
Step 16 Connect the Back Cards
Step 17 Connect the Console Port
Step 18 Connect Power to the switch
Connect AC Power to the Switch
•
Connect DC Power to the Switch
•
Step 19
Connect the External Clock (optional)
Step 20 Connect the Alarms (optional)
Step 21 Connect the MP Connection (optional)
Step 22 Connect the LAN1/2 Ports (optional)
Step 23 Verify EMI Compliance
After completing these steps, proceed to the
Note
section on page 5-137

Installation Procedures

The switch should not receive power while you install components.
Warning
The following sections describe how to install the MGX 8850, MGX 8850/B, and MGX 8880 systems.
Special Installation Notes for the MGX 8880 Media Gateway
Installing the MGX 8880 gateway varies from MGX 8850 installation in the following ways:
•
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-4
if this is a first-time installation.
The MGX 8880 DC version is 14 RUs. The AC version is 17 RUs. The new low profile cooling
system makes the space savings possible. Refer to
MGX 8880 space needs.
Chapter 5
Rack-Mounted System (with Lift)
"First Time Power On Procedure for MGX Switches"
Table 3-24
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Installing the Cisco MGX Switch or Gateway
Cisco Cabinet System
Connect the Alarms (optional)
Connect the MP Connection
(optional)
Connect the LAN1/2 Ports
(optional)
Verify EMI Compliance
and Table 3-25 when planning your