Removing Redundancy Connectors; Installing And Removing The Axsm-Xg Extender Connector; Installing The Extender Connector - Cisco MGX MGX 8800 Hardware Installation Manual
Cisco systems switches installation guide
Hide thumbs
Also See for Cisco MGX MGX 8800:
- Hardware installation manual (25 pages) ,
- User manual (4 pages)
Table of Contents
Advertisement
Chapter 6
Maintaining the Cisco MGX Switch or Gateway
Removing Redundancy Connectors
Remove power from the MGX 8850/B or MGX 8830/B switch before removing RCONs. Connector pins
Warning
near the RCON have hazardous voltages.
To remove RCONs, perform the following steps:
Step 1
Remove power to the chassis, either at the AC power supply or DC power source.
At the back of the chassis, remove back cards over the RCON.
Step 2
Remove the filler bars over the RCON. (MGX 8830/B only)
Step 3
Unscrew the RCON fasteners and lift the RCON off the mounting bar.
Step 4
Replace the filler bars. (MGX 8830/B only)
Step 5
Reinstall back cards.
Step 6
Restore power.
Step 7
Installing and Removing the AXSM-XG Extender Connector
The extender connector (MGX8950-EXTDR-CON) extends additional serial lines from the
AXSM-16-155-XG and AXSM-8-622-XG cards to the MGX 8950 backplane. Install or remove the
extender connector, as necessary, to satisfy the following requirements:
•
•
Remember to observe antistatic precautions when handling circuit boards. These precautions include
Note
using grounded wrist straps, antistatic bags, and antistatic work surfaces.
Installing the Extender Connector
To install the extender connector:
Place the AXSM-16-155-XG or AXSM-8-622-XG card on a flat antistatic surface.
Step 1
Locate an extender connector (MGX8950-EXTDR-CON) and mounting hardware. Usually, the
Step 2
mounting screws and washers are attached to the connector itself. If they are, remove them.
Insert the extender connector into the connector on the AXSM-16-155-XG or AXSM-8-622-XG card
Step 3
edge (see
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Cisco MGX 8950—The MGX8950-EXTDR-CON must be installed on AXSM-16-155-XG and
AXSM-8-622-XG cards. The cards require the extender connector for proper operation.
Cisco MGX 8850 or Cisco MGX 8830—The MGX8950-EXTDR-CON must not be installed on
AXSM-16-155-XG and AXSM-8-622-XG cards. The extender connector can damage the
backplane.
Figure
6-16).
Installing and Removing the AXSM-XG Extender Connector
Cisco MGX 8800/8900 Series Hardware Installation Guide
6-27
Advertisement
Table of Contents
