Preparing For Installation - Cisco MGX MGX 8800 Hardware Installation Manual

Preparing for Installation

This chapter lists the requirements for installing the Cisco MGX 8850, Cisco MGX 8850/B, Cisco MGX
8950, Cisco MGX 8830 and Cisco MGX 8830/B switches and their related components. It also lists
requirements for installing the Cisco MGX 8880 Media Gateway. The chapter includes the following
sections:
Safety Requirements, page 3-2
•
Site Requirements for the MGX 8850 or MGX 8850/B Switch, page 3-10
•
• Site Requirements for the MGX 8950 Switch, page 3-28
• Site Requirements for a MGX 8830 or MGX 8830/B Switch, page 3-41
• Site Requirements for the MGX 8880 Media Gateway, page 3-55
Unpacking the Box, page 3-69
•
Verifying Contents, page 3-70
•
Inspecting for Damage, page 3-70
•
The information in this guide does not apply to the MGX 8850 (PXM1) switch.
Note
Only trained and qualified personnel should install or replace this equipment.
Warning
This unit is intended for installation in restricted access areas. A restricted access area is where
Warning
access can only be gained by service personnel through the use of a special tool, lock and key, or
other means of security, and is controlled by the authority responsible for the location.
Warning Before you start the installation procedures, read the entire chapter for important information and
safety warnings.
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
C H A P T E R
Cisco MGX 8800/8900 Series Hardware Installation Guide
3
3-1