Front Cards; Ausm - Cisco MGX MGX 8800 Hardware Installation Manual

Cisco systems switches installation guide
Hide thumbs Also See for Cisco MGX MGX 8800:
Table of Contents

Advertisement

Front Cards

Front Cards

AUSM

Supported models: MGX 8830, MGX 8830/B, MGX 8850 (PXM1E), MGX 8850 (PXM1E)
AUSM cards are service modules that provide ATM Network-to-Network Interfaces (NNIs)/UNIs that
operate at T1 or E1 rates so that ATM UNI user devices can transmit and receive traffic.
Consistent with the Cisco intelligent quality of service (QoS) management features, AUSM cards
support per-virtual circuit (VC) queuing on ingress and multiple class-of-service queues on egress.
AUSM/Bs fully support continuous bit rate (CBR), variable bit rate (VBR), unspecified bit rate (UBR),
and available bit rate (ABR) service classes.
When the AUSM is combined with a back card, a card set is created.
about each AUSM, interface, and corresponding back card.
Table 2-8
AUSM
AUSM-8E1/B NNI/UNI
AUSM-8T1/B NNI/UNI
The AUSM cards also support ATM Forum-compliant inverse multiplexing over ATM (IMA) 1.0. This
capability enables multiple T1 or E1 lines to be grouped into a single high-speed ATM port. This n x T1
and n x E1 capability fills the gap between T1/E1 and T3/E3, providing bandwidth up to 12 Mbps
(n x T1) or 16 Mbps (n x E1), without requiring a T3/E3 circuit.
For information on AUSM software features and configurations, refer to the Cisco ATM Services
Note
(AUSM/MPSM-8-T1E1) Configuration Guide and Command Reference for MGX Switches, Release 5.2.
For technical specifications for the AUSM cards, see the
section on page
Cisco MGX 8800/8900 Series Hardware Installation Guide
2-10
Chapter 2
AUSM Cards, Interfaces, and Supported Back Cards
Interface
# of Lines
Connections
Supported
Up to 8
Up to 8
A-2.
Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Types of Lines
Supported
Supported Back Cards
E1 (up to 2.048
Mbps +/–50 bps)
T1 (up to 1.544
Mbps +/–50 bps)
"Single-Height Service Module Specifications"
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Table 2-8
provides information
MGX-RJ48-8E1 (for use in
Australia)
RJ48-8E1
R-RJ48-8E1
SMB-8E1
R-SMB-8E1
RJ48-8T1
R-RJ48-8T1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8900 series

Table of Contents