Cisco MGX MGX 8800 Hardware Installation Manual page 236

Back Cards
MGX-1GE
The MGX-1GE is a single-port high-speed uplink (Gigabit Ethernet) back card. The MGX-1GE is
installed in the upper rear bay back slot directly behind the RPM-XF.
The MGX-1GE uses SFP modules that support Gigabit Ethernet rates on SX, LH/LX, ZX and T Gigabit
Ethernet interface types. The following table provides details for the modules that are supported on the
MGX-1GE. The modules can be changed or upgraded.
SFP Description
GLC-SX-MM 1000Base SX
GLC-LH-SM 1000Base
LH/LX
GLC-ZX-SM 1000Base ZX
GLC-GE-T 1000BASE-T
(Copper)
Figure 2-50
Cables include: CAB-FIR-LC, CAB-MMF-LC, CAB-SMFLR-LC.
Cisco MGX 8800/8900 Series Hardware Installation Guide
2-106
Chapter 2
62.5/125 um 50/125 um
Multimode Multimode
850 nmCable 850 nmCable
220 M at 500 M at
160 MHz-km 400 MHz-km
275 M at 550 M at
200 MHz-km 500 MHz-km
— —
— —
— —
shows the MGX-1GE faceplate.
Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
62.5/125 um 50/125 um
Multimode Multimode
1310 nmCable 1310 nm Cable
— —
550 M at 550 M at
500 MHz-km 400 MHz-km
— —
— —
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
9/125 um
Singlemode Category 5
1310 nm Cable Cable
— —
10 km —
70 km —
— 100M