Figure 5-2 Stability Plate Dimensions - Cisco MGX MGX 8800 Hardware Installation Manual

Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Complete the following steps to anchor your Cisco cabinet to a stability plate:
Step 1 Drill holes into the floor to install the stability plate. See
Figure 5-2 Stability Plate Dimensions
6.7 in.,
17.02 cm
3.35 in.,
8.51 cm
45.72 cm
Step 2 Use four 3/8 x 1 inch anchoring bolts (user-provided) to attach the stability plate to the floor.
Step 3 Roll the Cisco cabinet over the stability plate as shown in
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-8
34.550 in., 87.76 cm
33.875 in.,
86.04 cm
18.0 in.,
Chapter 5
Figure 5-2
Cabinet
outline
3.35 in.,
8.51 cm
18.0 in.,
45.72 cm
Figure 5-3.
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Installing the Cisco MGX Switch or Gateway
for the dimensions.
0.337 in., 0.85 cm
0.663 in., 1.68 cm
9.5 in.,
24.13 cm
11.55 in.,
29.34 cm