Figure 1-26 Aps Assembly Example For Mgx 8950 (Mgx-Aps-Con-8950); Figure - Cisco MGX MGX 8800 Hardware Installation Manual

Cisco MGX 8950 Switch

Figure 1-26

are linked to an APS connector, they form an APS assembly. The APS assembly is installed in the rear
of the switch. For more information, see the
Figure 1-26
The following modules support the MGX 8950 APS connector (MGX-APS-CON-8950). For more
information about APS options and requirements, see
AXSM-1-2488/B
•
• AXSM-4-622/B
• AXSM-16-155/B
AXSM-1-9953-XG
•
AXSM-4-2488-XG
•
AXSM-8-622-XG
•
AXSM-16-155-XG
•
For information on APS configuration, refer to the appropriate Cisco MGX release notes, or the Cisco
MGX software configuration guide for your software release.
Cisco MGX 8800/8900 Series Hardware Installation Guide
1-42
shows an example of two back cards installed in an APS connector. When the two back cards
APS Assembly Example for MGX 8950 (MGX-APS-CON-8950)
Table 4-4.
Table 4-4.
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 1 Product Overviews